We get “Power supply voltage to low” error message in StyleLight Studio


If the internal voltage inside the StyleLight is to low when performing an upgrade this message is showed.

Try to switch USB port on the PC or if a USB hub is used try to connect StyleLight direct to the PC.
It could also be a problem with the USB cable. Try with another USB mini cable.

You could also try with powering the StyleLight from the OBD connector.
To do this first connect the StyleLight to the PC with USB cable and then connect it to the vehicle. After this run the upgrade process again.

How do I upgrade my StyleLight device?


To upgrade your device you need to install the “StyleLight Studio” software and have a valid device license.

Go to Download section and download the “StyleLight Studio” software and install it. When the installation is completed, start the application and connect the StyleLight device via USB cable. The device will be synchronized. If the device has a valid license the upgrade process will start if there is a newer firmware available.


When I connect the StyleLight 2 to the vehicle nothing happens, the red LED is flashing one time per cycle


The StyleLight couldn’t detect the profile of the vehicle.

This could either be that there is a bad connection between the device and vehicle or the vehicle profile is missing.
It is possible to manually set a vehicle profile by login to the StyleLight over Wi-Fi. To set the profile manually the “standalone” mode must first be unchecked under OPTIONS page. Then a custom profile could be set under PROFILE page.

Some of the indication signs in DIM is activated and deactivated after StyleLight 2 has been used


There is a bug on some of the DIM units that cause this problem.
There are three workarounds to this problem:

  1. Do a complete reset of the vehicle by pulling the battery power (+) for a couple of seconds and then connect the power again.
  2. Do a complete reset of the vehicle by connecting the StyleLight 2 to the OBD2 outlet and wait until the interior light make a flash and then immediately disconnect the StyleLight device.
  3. Lock the vehicle and wait until it goes to sleep, after about 20min.